Gents,
for those of you interested there is a Group Buy on Cast Boolits for a very useful mould for 50 cal levergun and 500 Linebaugh users. The base mould is a 500 gr 0.513 FN bullet with the crimp groove in the correct location for use in 50 cal leverguns.
The mould maker is providing a lot of options, including up to 4 cavities and a conventional HP option for one of the cavities. He also is providing an option for a new style of mould that has either 2 or 4 captive HP pins - these moulds are designated RG-2 or RG-4. With these new moulds you can produce a heap of HP bullets quite quickly. In addition the HP pins are interchangeble with FN pins to enable making FN bullets as well using the same mould. The design incorporates a long shank to take the long Gator 50 cal GC.
This would probably make it one of the most flexible moulds available for 50 cal leverguns.
Here's a link to the thread.
http://www.castboolits.gunloads.com/sho ... p?p=672323
Joe
Attention 50 Ak, 50/110 and other 50 cal users
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.