Receiver Sight Question

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
User avatar
BruceB
Levergunner 2.0
Posts: 248
Joined: Sat Sep 01, 2007 10:27 am
Location: So Cal

Receiver Sight Question

Post by BruceB »

I was looking at the Lyman and Williams receiver sights catalogs and noticed that the Williams FP-94/36 sight fits either the Winchester 94 or the Marlin 336. Lyman, on the other hand has two separate models, the 66A for the Winchester and the 66LA for the Marlin. Any idea what the difference is between the 66A and the 66LA is?
GOD SAVE THE UNITED STATES!

Original member of Leverguns.com forum

NRA Life Member

Boy, what a mess them .45's make.

When seconds mean life or death, the police are only minutes away.
Top
User avatar
J Miller
Member Emeritus
Posts: 14884
Joined: Sat Mar 31, 2007 7:46 pm
Location: Not in IL no more ... :)

Re: Receiver Sight Question

Post by J Miller »

Bruce,

The Lyman 66A has an angled surface at the top of the base that matches the contour of the Win 94s receiver.
The 66LA is flat on the back to match the Marlin.
The Williams FP-94/36 is also flat to fit both.
WilliamsLYMANmontage from SteveB.jpg

Joe
You do not have the required permissions to view the files attached to this post.
***Be sneaky, get closer, bust the cap on him when you can put the ball where it counts ;) .***
Top
User avatar
BruceB
Levergunner 2.0
Posts: 248
Joined: Sat Sep 01, 2007 10:27 am
Location: So Cal

Re: Receiver Sight Question

Post by BruceB »

Thanks.
GOD SAVE THE UNITED STATES!

Original member of Leverguns.com forum

NRA Life Member

Boy, what a mess them .45's make.

When seconds mean life or death, the police are only minutes away.
Top
Post Reply

Return to “General Discussion”