Who/Where can I get my 30-30...
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
-
Marlin336W
- Levergunner
- Posts: 9
- Joined: Fri Feb 29, 2008 9:15 am
Who/Where can I get my 30-30...
made into an Ackley Improved? I have a Marlin 336W carbine.
I think any guild quality gunsmith could do it. It is a fairly simple and straight forward operation. In fact lots of guys rent chamber reamers and do it themselves at home.
I always felt that if I had it done to one of my rifles I would want to use the same chamber reamer on a set of 30 WCF dies so that the rifle chamber and the dies were an exact match.
Wm
I always felt that if I had it done to one of my rifles I would want to use the same chamber reamer on a set of 30 WCF dies so that the rifle chamber and the dies were an exact match.
Wm
-
marlinman93
- Advanced Levergunner
- Posts: 6497
- Joined: Sun Apr 01, 2007 3:40 pm
- Location: Oregon
Might ruin a chamber reamer on a set of dies! They're much harder than a rifle barrel.
Pre WWI Marlins and Singleshot rifles!
http://members.tripod.com/~OregonArmsCollectors/
http://members.tripod.com/~OregonArmsCollectors/
Regan Nonneman does them www.leveractions.com
Steve Young most likely does .. or can www.stevesgunz.com
Steve Young most likely does .. or can www.stevesgunz.com