Question for those who know
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Question for those who know
Has anyone ever heard of a Winchester 94 with a twist rate of 1: 11.5 inches? I have a barrel that I am thinking of using to change one of my carbines into a rifle. It is (I hope) a 26" Centennial barrel and I have checked it twice. the twist rate is one full twist in 11.5 inches.
-
- Advanced Levergunner
- Posts: 4145
- Joined: Fri Dec 21, 2007 11:34 am
- Location: north of Palacios about 1400 miles
Re: Question for those who know
Well within "tolerances" 30/30's had either 1-10" or 1-12" twist. Thats less than 5% deviation. I'm sure there is few people that could explain it better than I did.
30/30 Winchester: Not accurate enough fer varmints, barely adequate for small deer; BUT In a 10" to 14" barrelled pistol; is good for moose/elk to 200 yards; ground squirrels to 300 metres
250 Savage... its what the 223 wishes it could be...!
250 Savage... its what the 223 wishes it could be...!
Re: Question for those who know
Thanks. I didn't think about tolerances!