OT: Mossberg Model 43 22LR bolt

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
3leggedturtle
Advanced Levergunner
Posts: 4145
Joined: Fri Dec 21, 2007 11:34 am
Location: north of Palacios about 1400 miles

OT: Mossberg Model 43 22LR bolt

Post by 3leggedturtle »

Friend has one of these and needs a magazine. Suggestions needed where to look/find one. Or if any other models interchanges with them. thanks
30/30 Winchester: Not accurate enough fer varmints, barely adequate for small deer; BUT In a 10" to 14" barrelled pistol; is good for moose/elk to 200 yards; ground squirrels to 300 metres

250 Savage... its what the 223 wishes it could be...!
User avatar
gamekeeper
Spambot Zapper
Posts: 17458
Joined: Thu Sep 06, 2007 3:32 pm
Location: Over the pond unfortunately.

Re: OT: Mossberg Model 43 22LR bolt

Post by gamekeeper »

I'd check out the Mossberg forum on Rimfirecentral.
Whatever you do always give 100%........... unless you are donating blood.
765x53
Senior Levergunner
Posts: 1049
Joined: Wed Jan 28, 2009 9:12 pm
Location: Bushwhacker Capitol, Missouri

Re: OT: Mossberg Model 43 22LR bolt

Post by 765x53 »

3leggedturtle
Advanced Levergunner
Posts: 4145
Joined: Fri Dec 21, 2007 11:34 am
Location: north of Palacios about 1400 miles

Re: OT: Mossberg Model 43 22LR bolt

Post by 3leggedturtle »

Thanks GK, went to RC and was told where to find one in less than an hour :D 765X53 went to the MC site and it sent me to the same place RC did
30/30 Winchester: Not accurate enough fer varmints, barely adequate for small deer; BUT In a 10" to 14" barrelled pistol; is good for moose/elk to 200 yards; ground squirrels to 300 metres

250 Savage... its what the 223 wishes it could be...!
Post Reply