Custom 348 Winchester Mold

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
johnly
Levergunner 1.0
Posts: 57
Joined: Fri Sep 14, 2007 5:18 pm

Custom 348 Winchester Mold

Post by johnly »

348 cast bullet shooters,the folks over at castboolits are putting together an order for a custom 225 gr. FN GC 6 cavity mold. The molds are $70 and have about a six month leade time. The 225 grain weight was selected to keep the gas check and lube bands in the case neck and away from the powder. You'll be kicking yourself if you order one of these

http://castboolits.gunloads.com/showthread.php?t=26399
Top
jtaylor1960
Levergunner
Posts: 35
Joined: Thu Sep 13, 2007 3:13 pm

348 MOLD

Post by jtaylor1960 »

I ordered one of them.It should be about a perfect all around mold for the 348.Being a six cavity you should be able to crank out the bullets in a short time.
Top
Post Reply

Return to “General Discussion”